Board
A.
A.
| WARNING Please proceed with the installation at your own risk as I will not be held responsible for any damage to your controller, your Playstation or any other equipment. Also know that opening your controller to do this mod will void your controller's warranty |
To be able to solder to the small copper circles, you must take a razor blade or something else with a
sharp tip to scrape the green paint that is over the small copper circles. You must take your time
when scraping at the paint so as not to damage the solder points. BE VERY CAREFUL. Soldering to
these small copper circles requires a steady hand.
sharp tip to scrape the green paint that is over the small copper circles. You must take your time
when scraping at the paint so as not to damage the solder points. BE VERY CAREFUL. Soldering to
these small copper circles requires a steady hand.
LED WIRING OPTION #2
THIS PART OF THE DIRECTIONS will COVER the install process by
soldering the new LED to the front of the controller.
THIS PART OF THE DIRECTIONS will COVER the install process by
soldering the new LED to the front of the controller.
LED WIRING OPTION #1
THIS PART OF THE DIRECTIONS will COVER the install process by
soldering A wire to the player 4 LED (IF YOU WOULD RATHER HAVE THE led IN THE FRONT SKIP TO OPTION #2)
In order for the mode indicator to be active. You
are going to want to cut a 4 inch piece of wire. Strip some
of the insulation off the ends of the wire, exposing the metal wiring.
Now, you are going to solder the wire to the BOTTOM of
the Player 4 LED. Be careful with thesoldering iron, BECAUSE to much
heat exposure will melt it and damage the LED.
Solder the wire to the BOTTOM of LED 4 as shown In the next picture. After
you get the wire soldered to the LED, carefully place the PCB back into the
controller, place the holding screw back in and screw it in tightly.
NOW SOLDER THE 4 INCH WIRE TO PIN number 2 ON THE PIC
THIS PART OF THE DIRECTIONS will COVER the install process by
soldering A wire to the player 4 LED (IF YOU WOULD RATHER HAVE THE led IN THE FRONT SKIP TO OPTION #2)
In order for the mode indicator to be active. You
are going to want to cut a 4 inch piece of wire. Strip some
of the insulation off the ends of the wire, exposing the metal wiring.
Now, you are going to solder the wire to the BOTTOM of
the Player 4 LED. Be careful with thesoldering iron, BECAUSE to much
heat exposure will melt it and damage the LED.
Solder the wire to the BOTTOM of LED 4 as shown In the next picture. After
you get the wire soldered to the LED, carefully place the PCB back into the
controller, place the holding screw back in and screw it in tightly.
NOW SOLDER THE 4 INCH WIRE TO PIN number 2 ON THE PIC
IF YOU HAVE PURCHASED THIS KIT TELL OTHERS HOW YOU LIKED IT
THANKS
BRIAN
SIGN THE GUEST BOOK HERE
view the guest book
THANKS
BRIAN
SIGN THE GUEST BOOK HERE
view the guest book
This video is just an overview on how to install the kit.
Double check your
wiring with this
schematic
wiring with this
schematic
Have you purchased from us?
This video is just a quick overview on how to install the kit.
 |  |  |  |  |  |  |  |  |  |
| . |
| . |
 |  |  |  |  |  |  |